Optimization of the thermal circuit by introduction of the steam screw-rotor machine

Abstract

The aim of the work is to increase the efficiency of the CHP by introducing a steam screw-rotor machine (SSRM) into the thermal circuit. It is proposed to exclude the passage of steam from the selection of the turbine through the pressure reduction and desuperheating station (PRDS) of own needs. Superheated steam is diverted to be sent to a steam screw-rotor machine installed parallel to the PRDS. This technical solution will allow to obtain steam used in low pressure deaerators, as well as electricity for own needs of the CHP. The article presents the operating parameters, as well as the calculation results of the backpressure turbine. A feasibility study was carried out for the introduction of SSRM into the plant’s thermal circuit: the equivalent fuel and electricity savings for own needs were calculated, as well as the payback period of the project for introducing a steam screw-rotor machine. In the course of the calculations, the following results were obtained: a decrease in the specific consumption of equivalent fuel for the production of 1 kWh of electricity – by 1,9 g; saving of equivalent fuel during the implementation of the SSRM will be 13 tons per year, which also entails a reduction in emissions into the environment; Electricity production for own needs is 8100 kWh, the payback period for the project to introduce a steam screw machine in the thermal circuit of a thermal power plant is 5 years.