Influence of cooling air selections on the efficiency of a gas turbine installation
https://doi.org/10.30724/1998-9903-2020-22-4-16-23
Abstract
A gas turbine installation (GTI) consists of 5 main parts: an input device, a compressor, a combustion chamber, a gas turbine, and an output device. In this work, due to the lack of sufficiently extensive information about stationary GTI, data from the characteristics of aviation GTI were partially used. The GTI operation efficiency is influenced by many factors, among which, apparently, the determining factor is the degree of air compression in the compressor π К . Of course, the compression ratio depends on the design scheme of the gas turbine, the type of fuel, the climatic conditions of operation, and others. The most important operational parameter of the GTI is the effective power NP and specific fuel consumption bud . The article provides a numerical analysis of the effect π К on NP and bud under variations in the temperature of gases at the turbine inlet T3 , as well as the influence of other factors, including the selection of part of the air for cooling high-temperature surfaces of the structure. The conclusions were made based on the calculations, the results of which are shown in the tables, and in the comparison graphs of obtained results.
About the Authors
I. I. Mubarakov
Kazan State Power Engineering University
Russian Federation
Russian Federation
Ilsaf I. Mubarakov
Kazan
A. B. Shigapov
Kazan State Power Engineering University
Russian Federation
Russian Federation
Ayrat B. Shigapov
Kazan
References
1. Uvarov VV. Gazovyeturbiny i gazoturbinnye ustanovki. M.: Vysshaya shkola, 1970. 320 p.
2. Shigapov AB. Statsionarnye gazoturbinnye ustanovki teplovykh elektricheskikh stantsii. Kazan': Izd. KGEU. 2006. 316 p.
3. Al-SoodM MA, Matrawy KK, Abdel-Rahim YM. Optimum operating parameters of an irreversible gas turbine cycle. Journal of Engineering Sciences, Assiut University. 2016;40(6):P.1695-1714.
4. Nkoi B. Advanced Cycles Large-Scale Aero-Derivative Gas Turbines: Performance Comparison. Journal of Power and Energy Engineering. 2016;4(05):7-19.
5. Linstrom PJ and Mallard WG. Eds., NIST Chemistry Web Book, NIST Standard Reference Database Number 69, National Institute of Standards and Technology, Gaithersburg MD, 20899, http://webbook.nist.gov. Accessed to:October 12, 2015.
6. Khasanov NG, Shigapov AB. Optimal'naya stepen' szhatiya vozdukha v gazoturbinnoi ustanovke s promezhutochnym vozdukhookhladitelem. Izvestiya vuzov. Problemy energetiki.2017;1-2:108-118.
7. Carl Knopf. Modeling, Analysis and Optimization of Process and Energy Systems. John Willey & Sons, New Jersey, 2012. 488 p.
8. Philip J Thomas. Simulation of industrial Process for Control Engineers. London, ButterworthHeinemann 1999. 390 p.
9. Arora R, Kaushik SP, Kumar R. Performance analysis of Brayton heat engine at maximum efficient power using temperature dependent specific heat of working fluid. Journal of Thermal Engineering. 2015;1(2):345354.
10. Shigapov AB, Kutlubaev IT. Raschetnye formuly osnovnykh pokazatelei parogazovykh blokov s uchetom real'nykh parametrov rabochikh tel. Izvestiya vysshikh uchebnykh zavedenii. Problemy energetiki. 2015;(1-2):26-32
11. Zakirov MU, Lokai VI, Sal'nikov GM. Termodinamicheskie raschety v turbomashinakh s uchetom peremennoi teploemkosti rabochego tela. Kazan': Izd. Kaz. aviats. inst.-t., 1976, 91 s.
12. Sabine Ausmeier. Innovative Gasturbinen-ProzessezurSteigerung von Wirkungs – grad und Wirtschaftlichkeit. Dissertation zur Erlangungdes Akademischen Grades Doktor-Ingenieurin. Essen, 08. Oktober 2002.
13. Hayhurst AN, Vince IM. Nitric Oxide Formation from N2 in Flames: the importance of promt NO/ Prog. Energy Combust Sci.1980 V. 6.
14. Khasanova NG. Izmeneniya termodinamicheskikh svoistv v trakte GTU [dissertation. …]
15. Khasanov NG, Shigapov AB. Vliyanie neideal'nosti rabochikh tel na optimal'nuyu stepen' povysheniya davleniya v kompressore GTU s promezhutochnym okhlazhdeniem tsiklovogo vozdukha. Teplovye protsessy v tekhnike. 2017;9(10):472-479.
Review
For citations:
Mubarakov I.I., Shigapov A.B. Influence of cooling air selections on the efficiency of a gas turbine installation. Power engineering: research, equipment, technology. 2020;22(4):16-23. (In Russ.) https://doi.org/10.30724/1998-9903-2020-22-4-16-23
Views:
476
Email this article 