MODERNIZATION OF THE FLOW SECTION OF THE MAIN CIRCULATION PUMP GCN 22600-87
https://doi.org/10.30724/1998-9903-2018-20-7-8-63-70
Abstract
In the presented work, a new version of the design of the flow-through part of the main circulation pump for NPPs with increased energy indices is proposed. This design solution allows to increase the efficiency of the pump from 82 -83% to 88-89%. Numerical hydrodynamic calculations of the viscous fluid flow in the ANSYS CFX environment of various variants of the pump design have been performed: a spherical chamber with guide vanes, a spiral tap, a spiral tap with discharge openings in a spherical chamber (new design). As a result of the hydrodynamic calculations, the values of the hydraulic efficiency of the variants considered were obtained. As a result of the analysis of the pattern of the flow of the investigated variants, it is established that the proposed version of the pump with unloading holes has additional hydraulic losses due to circulation of the flow through them. The value of the circulation of the flow through the discharge openings is numerically obtained. The cause of the detected effect was investigated. As a result of the conducted research it is established that it is possible to further increase the efficiency of the proposed pump design by optimizing the geometry of the discharge openings.
About the Authors
E. A. Ivanov
OAO NPO CKTI, Saint-Petersburg
Russian Federation
Russian Federation
Evgeniy Ivanov – engineer
V. A. Kalaev
OAO NPO CKTI, Saint-Petersburg
Russian Federation
Vladimir Kalaev – professor, PhD
Russian Federation
Vladimir Kalaev – professor, PhD
S. A. Shumilin
OAO NPO CKTI, Saint-Petersburg
Russian Federation
Sergey Shumilin – leading engineer, PhD
Russian Federation
Sergey Shumilin – leading engineer, PhD
References
1. Zharkovskiy A.A. Morozov M.P.. Shumilin S.A. Matematicheskiye modeli rabochikh protsessov lopastnykh gidromashin. Avtomatizirovannoye proyektirovaniye i otsenka energokavitatsionnykh pokazateley lopastnykh sistem. SPb. Izdatelstvo SPbGPU. 2002 g. 47 s
2. Raukhman B.S. Reshetka profiley v proizvolnom sloye peremennoy tolshchiny. - Tr. Tsentr. kotloturbin. in-ta. 1971. № 1. s. 83-89
3. Raukhman B.S. Usovershenstvovaniye metodiki profilirovaniya lopastnykh sistem gidromashin. – Tr. Tsentr. kotloturbin. in-ta. 1978. vyp. 164. s. 21 -32.
4. Golikov V.A. Razrabotka i chislennoye issledovaniye lopastnoy sistemy nasosa: uchebn. Posobiye / V.A. Golikov. D.A. Korepanov. P.V. Pugachev. – SPb.: Izd-vo Politekhn. un-ta. 2016. – 220 s.
5. Lomakin A.A. Tsentrobezhnyye i osevyye nasosy. L.: Mashinostroyeniye. 1966. 364 s.
6. Lopastnyye nasosy: Spravochnik; Pod obshch. red. V.A. Zimnitskogo i V.A. Umova. – L.: Mashinostroyeniye. Leningr. otd-niye. 1986. – 334 s.: il. 2.
7. Nasosy AES. Spravochnoye posobiye pod redaktsiyey P.N. Paka. Energoatomizdat. 1989 g.. 328 s.
8. Kazantsev R.P. Konstruktsii protochnykh chastey glavnykh tsirkulyatsionnykh nasosov (GTsN) dlya energeticheskikh blokov AES. // Trudy mezhdunarodnoy n -t konferentsii. SPb. Izdatelstvo SPbGPU. 2006 g. S. 108-?11.
9. Martsinkovskiy V.A.. Vorona P.N. Nasosy atomnykh elektrostantsiy. – M.: Energo-atomizdat. 1987. – 256 s.: il.
10. Robozhev A.V. Nasosy dlya atomnykh elektrostantsiy. M.: Energiya. 1979. 135 s.
11. Budov V.M. Nasosy AES. - M.: Energoatomizdat. 1986. s 401.
12. Mityankov F.M.. Novinskiy E.G.. Budov V.M. Glavnyy tsirkulyatsionnyy nasos AES. M . Energiya. 1985. – 316 s.
13. Pak P.N.. Belousov A.Ya. Nasosnoye oborudovaniye atomnykh stantsiy. – M.: Energoatomizdat. 2003 g. 446
Review
For citations:
Ivanov E.A., Kalaev V.A., Shumilin S.A. MODERNIZATION OF THE FLOW SECTION OF THE MAIN CIRCULATION PUMP GCN 22600-87. Power engineering: research, equipment, technology. 2018;20(7-8):63-70. (In Russ.) https://doi.org/10.30724/1998-9903-2018-20-7-8-63-70
Views:
609
Email this article 