THE DEFINITION OF THE OPTIMAL AREAS OF INPUT OF SOLID ADDITIVES INTO THE AIR INLET OF THE BOILER
https://doi.org/10.30724/1998-9903-2017-19-9-10-106-111
Abstract
The conditions of operation of the main and auxiliary equipment of TPPs essentially depend on the quality of fuel oil. The article considers the problem of improving the combustion process of fuel oil and associate produced by burning of sulfur oxides due to the introduction of additives. A part of the duct of the boiler is simulated up to the burners, where the additive particles are introduced. Areas of entrainment of particles in the duct of the boiler are investigated for uniform addition of the additive.
About the Authors
O. S. Dmitrieva
Kazan State Power Engineering University, Kazan
Russian Federation
Cand. Sci. (Techn.), senior researcher, Department “Theoretical Foundations of Thermal Engineering”
Russian Federation
Cand. Sci. (Techn.), senior researcher, Department “Theoretical Foundations of Thermal Engineering”
S. F. Loraj
Military representation of the Ministry of defense of the Russian Federation,
Kazan
Russian Federation
Russian Federation
chief of 744 Military representation of the Ministry of defense of the Russian Federation in Kazan
V. Je. Zinurov
Kazan State Power Engineering University, Kazan
Russian Federation
Russian Federation
student
Je. R. Zvereva
Kazan State Power Engineering University, Kazan
Russian Federation
Dr. Sci. (Techn.), professor, Department “Water and fuel technology”
Russian Federation
Dr. Sci. (Techn.), professor, Department “Water and fuel technology”
M. F. Shageev
Kazan State Power Engineering University, Kazan
Russian Federation
Russian Federation
Cand. Sci. (Techn.), associate professor, Department of “Electric stations”
References
1. Kannaiyan K., Sadr R. The effects of alumina nanoparticles as fuel additives on the spray characteristics of gas-to-liquid jet fuels. Experimental Thermal and Fluid Science. 2017. V. 87. P. 93-103. DOI: 10.1016/j.expthermflusci.2017.04.027.
2. Mitusova T.N., Lyubimenko V.A., Nedayborshch A.S. Issledovanie sovmestimosti prisadok razlichnogo funkcional''nogo naznachenija k dizel''nym toplivam metodom komp''juternogo modelirovanija [Study of thecompatability of the additives of different functional designation to the diesel fuelby the computer simulation method] // Neftepererabotka i neftehimija. Nauchno-tehnicheskie dostizhenija i peredovoj opyt. 2015. issue 5. pp. 32-36.
3. Ziganshin M.G., Ezhov P.V., Dmitriev A.V. Jeffektivnost' ochistki gazovyh vybrosov parogeneratorov TJeS v apparatah vihrevogo tipa [Efficiency of cleaning gas emissions of TPP steam generators in vortex-type devices] // Promyshlennaja jenergetika. 2008. issue 9. pp. 49-53.
4. Kalimullin I.R., Dmitriev A.V. Perspektivy ispol'zovanija absorbentov na osnove tretichnyh aminov dlja povyshenija jeffektivnosti ochistki gazov v apparatah vysokoj propusknoj sposobnosti [Prospects for the use of tertiary amine based absorbents to improve the efficiency of gas cleaning in high-throughput devices]. Vestnik Kazanskogo tehnologicheskogo universiteta. 2011. issue 3. pp. 143-145.
5. Saidakhmedov A.I., Karpov S.A., Kapustin V.M. Effect of cottonseed oil additives and etherification products on diesel fuel properties. Chemistry and technology of fuels and oils. 2011. V. 47. issue 5. pp. 331-336. DOI: 10.1007/s10553-011-0303-2.
6. Danilov A.M. Razvitie issledovanij v oblasti prisadok k toplivam (obzor) [Progress in research on fuel additives (review)] // Neftehimija. 2015. V. 55. issue 3. p. 179. DOI: 10.7868/S0028242115030028.
7. Kapustin V.M. Neftjanye i al'ternativnye topliva s prisadkami i dobavkami [Oil and alternative fuels with additives and additives]. Moscow. KolosS, 2008. 232 p.
8. Zvereva Je.R., Ganina L.V. Pat. 2363722 RF. Prisadka k mazutu [Additive for fuel oil]. Izobretenija. Poleznye modeli. 2009. issue 22. (Publ. 10 august 2009).
9. Zvereva Je.R., Dmitriev A.V., Shageev M.F., Ahmetvalieva G.R. Rezul'taty promyshlennyh ispytanij karbonatnoj prisadki k mazutu [Results of industrial tests of carbonate additive to fuel oil] // Teplojenergetika. 2017. issue 8. pp. 50-56. DOI: 10.1134/S0040363617080112.
10. Zvereva E.R., Khabibullina R.V., Zueva O.S. Nano additives influence on fuel oil properties. Solid state phenomena. 2017. V. 265. P. 374-378. DOI: 10.4028/www.scientific.net/SSP.265.374.
Review
For citations:
Dmitrieva O.S., Loraj S.F., Zinurov V.J., Zvereva J.R., Shageev M.F. THE DEFINITION OF THE OPTIMAL AREAS OF INPUT OF SOLID ADDITIVES INTO THE AIR INLET OF THE BOILER. Power engineering: research, equipment, technology. 2017;19(9-10):106-111. (In Russ.) https://doi.org/10.30724/1998-9903-2017-19-9-10-106-111
Views:
399
Email this article 